Ycarus Gentoo ebuild

Systole

These ebuilds come from .

If you have some problems, go to the official site first.

Slicer-Scripted

DataProbe : DataProbe module for 3D-Slicer ( https://www.slicer.org/ )

Editor : Editor module for 3D-Slicer ( https://www.slicer.org/ )

EditorLib : EditorLib module for 3D-Slicer ( https://www.slicer.org/ )

Endoscopy : Endoscopy module for 3D-Slicer ( https://www.slicer.org/ )

LabelStatistics : LabelStatistics module for 3D-Slicer ( https://www.slicer.org/ )

PerformanceTests : PerformanceTests module for 3D-Slicer ( https://www.slicer.org/ )

SampleData : SampleData module for 3D-Slicer ( https://www.slicer.org/ )

ScreenCapture : ScreenCapture module for 3D-Slicer ( https://www.slicer.org/ )

SegmentEditor : SegmentEditor module for 3D-Slicer ( https://www.slicer.org/ )

Add an ebuild in portage :

The ebuild is now in the portage tree.

You can also use layman : emerge layman then layman -a Systole

For Paludis use this rsync : rsync://gentoo.zugaina.org/Systole-portage

If you have a problem : ycarus(-at-)zugaina.org